RELM two-way radio Průvodce řešením problémů stáhnout pdf (Strana 18)

2. Rotate the “Channel Selector” knob to select the wanted channel.

3. Make sure there is no activity on the channel.

4. Press the PTT key and speak into the microphone with your mouth 1- 2 inches

away from the radio. The LED glows red during transmission.

5. Release the PTT key to finish transmission.

Receive

1. Turn on the radio.

2. Rotate the “Channel Selector” knob to select the wanted channel.

3. Adjust the volume.

4. If vibration mode is set and a call is received, the radio will alert you with

vibration and no audio will be heard. The LED glows green during receiving.

5. When CTCSS/CDCSS or squelch tail elimination feature is set by your dealer:

• No squelch tail will be heard at the end of a received transmission when the

courtesy tone is disabled.

• A beep tone sounds at the end of a received transmission when the courtesy

tone is enabled.

Please contact your dealer for more details.

Monitor

1. Press Monitor key to monitor the current channel.

2. Press Monitor key again to exit.

3. Your dealer can set three monitor modes: SelCall monitor, CTCSS monitor and

Carrier monitor.

SelCall monitor: Radio shields selective call squelch condition when monitoring,

monitor status is activated if carrier and CTCSS are matched.

CTC/DCS monitor: Radio shields all signalling squelch condition when monitoring,

monitor status is activated if carriers are matched.

Carrier monitor: Radio shields all squelch condition and speaker is directly open.

4. If keep pressing monitor key more than 2 seconds, radio will be in stable monitor

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Žádné komentáře

RELM two-way radio Průvodce řešením problémů Strana 18