RELM two-way radio Průvodce řešením problémů stáhnout pdf (Strana 20)

Scan

Scan feature allows you to monitor activities on all channels for receiving call from

these channels.

When scan feature is enabled, the radio will detect calls from all channels. If an

active channel is detected, the radio will switch to that channel so that to receive an

incoming call(Channels must be programmed to be included in scan list).

Disable/Enable Scan Feature

1. Press the scan key to begin scanning.

2. Press the scan key again to stop scanning.

The LED flashes green in scan mode.

Callback

The radio will transmit on the callback channel if the PTT key is pressed while

scanning.

Please contact your dealer for more details about callback channel.

Nuisance Channel Delete

Nuisance channel delete feature allows you to temporarily delete an unwanted

channel from the scan list.

When the radio stops on the nuisance channel, press the programmed Nuisance

Delete key until an alert tone sounds to delete this channel.

When scan feature is enabled again, the deleted channel will return to the scan list.

Note: Priority channel cannot be deleted.

Priority Channel Scan

This feature allows you to scan important channels. The dealer can program a

channel as priority channel through the programming software.

Note: The radio will constantly monitor the priority channel when it stops on a

non-priority channel. If activity is detected on the priority channel, the radio will revert

to the priority channel and remain there as long as the channel stays active.

Please contact your dealer for more details.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Žádné komentáře

RELM two-way radio Průvodce řešením problémů Strana 20